MTD 27-Ton Servisní příručka stáhnout pdf (Strana 52)

2010 Log Splitters

Beam

To remove/replace the beam:

1. With the engine turned-off, relieve hydraulic pressure from the system by moving the lever on the control valve

through it’s full range of travel.

NOTE: If the shop has equipment that can safely lift the cylinder without straining the hydraulic lines, this job

can be done without disconnecting the hoses.

2. Thoroughly clean all dirt and debris from around the

valve.

NOTE: Any dirt or debris that gets inside the valve

can destroy it.

3. Place a suitable container under the valve to catch

any fluid that will leak out as the hydraulic lines are

removed.

See Figure 6.3.

4. Loosen the hose clamp on the low pressure return

line using a 5/16” wrench.

5. Disconnect the low pressure return line.

6. Disconnect the high pressure hose from the pump.

7. Disconnect the high pressure supply hose from the

valve using a 15/16” wrench.

See Figure 6.4.

Hydraulic fluid under high pressure can be dangerous. A high-pressure hydraulic fluid leak or

spray can penetrate the skin. If this happens, seek immediate medical attention to reduce the

risk of blood poisoning, which can lead to death or limb amputation.

Figure 6.3

low pressure

return line

Figure 6.4

Control valve

high pressure

supply hose

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Žádné komentáře

MTD 27-Ton Servisní příručka Strana 52