MTD RZT Series Návod k obsluze stáhnout pdf (Strana 18)

18 se c t i O n 5— Op e r a t i O n

Operating The PTO



Move the throttle control lever to approximately the 

mid throttle position.



Advance the throttle lever to the operating speed (full 

engine speed).

The operator must remain in the tractor seat at all 

times. If the operator should leave the seat without



engine will shut off.





when both drive control levers are moved to the

reverse position, and will re-engage when one (or

both) control lever(s) is moved to the neutral or forward

position.

Using the Mower Deck

WARNING!: Make certain the area to be

mowed is free of debris, sticks, stones, wire

or other objects that can be thrown by the

rotating blades.

IMPORTANT: Do not engage the mower deck when lowered in

grass. Premature wear and possible failure of the ‘V” belt and

PTO clutch will result. Fully raise the deck or move to a non

grassy area before engaging the mower deck.

Mow across slopes, not up and down. If mowing a 

slope, start at bottom and work upward to ensure turns

are made uphill.



the area to be mowed.



the throttle control to the fast position.

Lower the mower deck to the desired height setting 

using the lift handle.



levers forward to move the tractor forward, and keep

the tractor headed directly toward the alignment point.

NOTE: The speed of the tractor will affect the quality of

the mower cut. Mowing at full speed will adversely affect

the cut quality. Control the ground speed with the control

levers.

When approaching the other end of the strip, slow 

down or stop before turning. A U-turn is recommended

unless a pivot or zero turn is required.

Align the mower with an edge of the mowed strip and 

overlap approximately 3 inches.

Direct the tractor on each subsequent strip to align 

with a previously cut strip.

To prevent rutting or grooving of the turf, if possible, 

change the direction that the strips are mowed by

approximately 45° for the next and each subsequent

mowing.

WARNING!: 



raise the deck to the highest position before

crossing.

IMPORTANT: When stopping the tractor for any reason while

on a grass surface, always:





Shut engine off and remove the key. 

Doing so will minimize the possibility of having your 



running engine.

Checking the Safety Interlock Circuits



they are working properly. If a safety circuit is not working

as designed, contact your authorized MTD Service dealer



if any safety circuit is not functioning properly. To check

the safety circuits, proceed as follows:

Sitting in the tractor seat with both drive control levers 

opened fully outward, disengage the parking brake

and momentarily turn the ignition switch to the start

position. The engine should not crank.



upward to the engaged position. Momentarily turn the

ignition switch to the start position; the engine should

not crank.



position and engage the parking brake. Start the

engine and move one of the drive control levers from

the fully outward neutral position. The engine should

stop running. Repeat the procedure with the opposite

control lever.

Move both control levers fully outward in the neutral 

position and disengage the parking brake; then lift



stop.

With both control levers fully outward in the neutral 

position and the parking brake engaged, engage the



should stop.

Start the tractor, disengage the parking brake, and 

move the control levers inward to the neutral operating





disengage and the mower deck should stop until one

or both of the control levers is moved to the neutral or

forward position.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Komentáře k této Příručce

Žádné komentáře

MTD RZT Series Návod k obsluze Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Traktor MTD RZT Series