Mtd 248-650A Uživatelský manuál stáhnout pdf (Strana 4)

PRE-ASSEMBLY

NOTE

The right and left side of your shred

der is determined from operator’s

position.

Before any step is undertaken, the instructions for

that step should be read through.

TOOLS REQUIRED:

1. (1) 7/16” Open End or Box Wrench

2. (1) 1/2” Open End or Box Wrench

3. (1) Adjustable Wrench.

MATERIALS REQUIRED:

1. Funnel (for gas and oil—NOTE: Do not mix).

2. S.A.E. 30 011—23/4 pints.

3. Gas (regular).

4. Cleaning rag.

PARTS IN CARTON

B

§ m

rrji rrri rrrt q™

rm nni ETii mi

FIGURE 2.

ASSEMBLY

INSTRUCTIONS

FIGURE 1.

NOTE

The letters listed below will be re

ferred to throughout the following

text for easier hardware identifica

tion.

LIST OF CONTENTS IN HARDWARE PACK:

A (3) Hex washer head self threading screws

B (4) Hex screws V4-20 X V2” long

C (4) Hex center locknuts ■'A-20 thread

D (4) Hex screws V4-2O x V2” long

E (4) Lockwashers ■'A” screw

F (4) Hex center locknuts Va-20 thread

1. Remove the shredder, parts pack and all

literature from the carton before discarding

carton.

2. Chute Deflector:

A. Place the chute deflector, in position on

the left hand side of shredder.

B. Secure with four hex screws (D), lock-

washers (E) and hex center locknuts (F).

See figure 3.

NOTE

Heads of screws are assembled

from the inside, nuts and washers

go on the outside. Start all four

screws, nuts and washers by hand,

then tighten with an adjustable

wrench and 7/16” wrench.

1 2 3 4 5 6 7 8 9 ... 14 15

Komentáře k této Příručce

Žádné komentáře