Mtd 24640-7 Uživatelský manuál Strana 1

TEN CENTS

047-640^24640'^10

LIST FOR LOG SPLITTER MODELS 247-640A and 24640-7..ef.No.PartNo.ColorCodeDescriptionNewPartRef.No.PartNo.ColorCodeDescriptionNewPart1710-0331 HexScr.

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the aut

IM PORTANTIt is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep this manual in a safe place for futu

ASSEMBLY INSTRUCTIONS^^>*-^Remove the log splitter, parts pack all all literature Tom the crate before discarding crate.2. Block up rear end o

FIGURE 43. The hydraulic system takes 4-1/2 gallons of low 30 HD only detergent oil. Fill the reservoir tank to the bottom of the fill

FIGURE 6FIGURE 7NOTEAfter engine has been serviced, finish filling oil reservoir. Start engine and operate engagement handle so the ram makes

E. Slowly move engagement handle forward until ram rests against log. Release engagement handle (Neutral).F. Remove your hand from the

HOSE CLAMPSCheck the hose clamps on the bottom of the pump for proper tightness before each use. See figure 14.lose clamps on the return

E. Clean and reassemble using a hydraulic sealant on the threads.ENGINE MAINTENANCETo obtain long life and trouble-free service from your eng

Hold throttle lever closed or move carburetor control to IDLE or SLOW position and adjust idle adjusting needle until engine runs s