MTD 600 SERIES Návod k obsluze Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 32
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
2_
Place chute assembly onto chute base and secure chute
control assembly to chute support bracket with clevis pin
and cotter pin removed earlier. See Fig. 3-13.
4. Insert the chute directional control rod into the support
bracket on the rear of the dash panel. See Fig. 3-15.
3_
Figure 3-13
Finish securing chute control assembly to chute support
bracket with wing nut and hex screw removed earlier.
See Fig. 3-14.
Figure 3-14
5_
f
J
Figure 3-15
Remove the hairpin clip from the rear of the chute control
assembly. See Fig 3-16.
Figure 3-16
6_ Secure the chute directional control rod to the chute
control assembly with the hairpin clip removed earlier.
See Fig 3-16.
SECTION3 -- ASSEMBLY& SET-UP 11
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Komentáře k této Příručce

Žádné komentáře