MTD 21AA413H700 Návod k obsluze stáhnout pdf

Operator's Manual

Rear Tine Tiller

Model Series 410

IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY

Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-

covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting

applicable local or state laws (if any), If a spark arrester is used, it should be maintained in effective working order by the operator,

In the State of California the above is required by law (Section 4442 of the California Public Resources Code), Other states may have

similar laws, Federal laws apply on federal lands, A spark arrester for the muffler is available through your nearest engine authorized

service dealer or contact the service department, P,O, Box 361131 Cleveland, Ohio 44136-0019,

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

PRINTED IN U.S.A. FORM NO. 770-10136E

(10/05)

1 2 3 4 5 6 ... 23 24

Shrnutí obsahu

Strany 1 - Operator's Manual

Operator's ManualRear Tine TillerModel Series 410IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYWarning: This unit is equipped with an in

Strany 2 - CUSTOMERSUPPORT

SECTION4: OPERATINGYOURTILLER,_ WARNING: Read, understand, and followall instructions and warnings on themachine and in this manual beforeoperating.Be

Strany 3 - Operation

• When using the tiller for the first time, use thesecond adjustment hole from the top (1" of tillingdepth). See Figure 9.Use This Position _Firs

Strany 4 - YourResponsibility

SECTION5: MAKINGADJUSTMENTS_, WARNING: Never attempt to make anyadjustments while the engine is running,except where specified in operator'smanua

Strany 5 - AttachingHandleAssembly

SECTION6: MAINTAININGYOURTILLER_, WARNING: Disconnect the spark plug wireand ground it against the engine beforeperforming any repairs or maintenance.

Strany 6 - AttachingClutchCable

NOTE:Upon reassembly, make certain the belt isrouted over the idler pulley and inside of belt keepers byengine pulley. See Figure 10.I EnginePulley Be

Strany 7 - Tire Pressure

SECTION7: TROUBLESHOOTINGGUIDEPossible Cause(s)Fuel tank empty, or stale fuel.TroubleEngine fails tostartEngine runserraticEngine overheatsTines do no

Strany 8 - SECTION3: KNOWYOURTILLER

SECTION8: PARTSLISTFORMODELSERIES410581232829\ I321\162526 3,1835IIIi 41II194O3916

Strany 9

ModelSeries410Ref.Part No.No.1. 710-10172. 786-01683. 686-00954. 712-040635. 715-01206. 786-01177. 710-30088. 712-30109. 736-024210. 710-318011. 710-1

Strany 10 - SECTION4: OPERATINGYOURTILLER

ModelSeries410323638924252313\\322518

Strany 11 - OperatingtheTiller

ModelSeries410Ref.Part No.No.1. 721-03782. 712-03783. 736-04074. 721-03795. 716-08656. 686-00387. 618-0245B9. 713-023310. 750-057011. 736-016312. 750-

Strany 12 - SECTION5: MAKINGADJUSTMENTS

This Operator's Manual is an important part of your new tiller. It will help you assemble, prepareand maintain the unit for best performance. Ple

Strany 13 - Lubrication

ModelSeries4103/1o_-7231025_/ 2617J jJJJJJ J _1 JJJ JJJJ\/v3217 42_4320

Strany 14 - Off-SeasonStorage

ModelSeries410Ref.No.1.2.3.4.5.6.7.8.9.10.11.12.13.14.15.16.17.18.19.20.21.22.23.24.Part No.710-1017786-0131710-0896720-0278A735-0246647-0014786-01187

Strany 15

NOTES22

Strany 16

NOTES23

Strany 17 - ModelSeries410

MANUFACTURER'S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC withrespect to new merchandise purchased and used in

Strany 18

SECTION1: IMPORTANTSAFEOPERATIONPRACTICESWARNING: This symbol points out important safety instructions which, if not followed, couldendanger the perso

Strany 19

7. Neveroperatethemachineathightransportspeedsonhardorslipperysurfaces.8. Exercisecautiontoavoidslippingorfalling.9. Lookdownandbehindandusecarewhenin

Strany 20

SECTION2: ASSEMBLINGYOURTILLERNOTE: This operator's manual covers various modelsof tillers. The units illustrated may vary slightly fromyour unit

Strany 21

Retainer BracketShoulder Bolt & Lock NutFigure 3• Place the hex opening of the flange nut retainerbracket over the flange nut securing the handlea

Strany 22

• Remove one hex nut from the threaded casing onthe end of the cable. Slip the wire up through theslot on the cable bracket underneath the handle.• Pu

Strany 23

SECTION3: KNOWYOURTILLERHandleHandleHandle Adjustment_HandleStakeModel 410 SeriesFigure 8WARNING: Read, understand, and follow Reverseall instructions

Strany 24

ChokeLever(if Equipped)The choke lever is located on top of the carburetor onthe back of the engine underneath the muffler. It is usedto enrich the fu