MTD 570 Series Uživatelský manuál stáhnout pdf (Strana 14)

for the user and the qualiﬁed installer

3. Fault elimination by the user

4. Fault elimination by the qualiﬁed installer

Table 3

Table 4

5. Guarantee

For guarantees please refer to the pespective terms and conditions of supply for your country.

The installation, electrical connection and ﬁrst operation of this appliance should be carried out by a

qualiﬁed installer.

The company does not accept liability for failure of any goods supplied which accor-dance with the

manufacturer‘s instructions.

5.1 Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with thenational

regulations for waste processing.

Fault

Cause

Remedy

Flow too weak

Jet regulator furred or soiled.

Clean or if necessary renew the ﬁtting jet regu-

lator (see „2.11 Special accessories“).

Filter soiled.

Clean the ﬁlter in the cold water inlet

(2)

after shutting off the water supply.

Heating fails to switch on / no hot

water.

No electrical power.

Check the fuse (house installation).

Heating system defective. Measure heating system resistance, if necessary

exchange the unit.

The pressure limiter has released

Determine and eliminate the cause for the fault.

Disconnect from power and relieve the pressure.

Reactivate pressure limiter

(a).

Fault Cause Remedy

No hot water despite fully opened hot

water ﬁtting.

No electrical power. Check the fuses in the house installation.

The turn on ﬂow rate needed to switch on the

heating power has not been reached. Soiling or

furring of the jet regulator.

Clean or if necessary renew the jet regulator

(see „2.11 Special accessories“).

272867-34655-0751 MTD 350 - 570.14 14 30.01.2008 16:19:51

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Komentáře k této Příručce

Žádné komentáře

MTD 570 Series Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Rozdělovače protokolů MTD 570 Series