MTD 550 Thru 570 Návod k obsluze stáhnout pdf (Strana 5)

SECTION2: ASSEMBLINGYOURLOGSPLITTER

UnpackingfromCrate

• Pry top, sides, and ends off the crate. Set panels

aside to avoid tire puncture or personal injury.

• Remove and discard plastic bag that covers unit.

• Remove any loose parts if included with unit (i.e.,

operator's manual, etc.)

• Cut and remove straps which secure parts to

bottom of crate. Unbolt any remaining parts which

may be bolted to the bottom of the crate.

WARNING" Use extreme caution unpacking

this machine. Some components are very

heavy and will require additional people or

mechanical handling equipment.

LoosePartsIn Carton

• Tongue assembly

• Tail light kit (optional)

BeforeAssembly

• Disconnect the spark plug wire and ground against

the engine to prevent unintended starting.

NOTE: Reference to right or left hand side of the log

spfitter is observed from the operating position.

Assemblingthe Tongue

Attachingthe JackStand

• The jack stand is shipped in the transport position.

Remove the spring clip and clevis pin and pivot the

jack stand towards the ground to the operating

position.

• Secure the jack stand in position with the clevis pin

and spring clip. See Figure 1.

1Spring Clip

Jack

Stand

Bracket

Lock

Washer

Hex Nut

Figure I

Hex Bolt

Washer

AttachingtheTongue

• With the log splitter still standing upright, remove

two hex bolts, lock washers, and hex nuts from the

end of the tongue. See Figure 1.

• Align the holes in the tongue with the holes in the

tank bracket and secure with hardware just

removed. See Figure 1.

NOTE: High pressure hose must be above the tongue

assembly.

ConnectingCylindertoBeam

• The log splitter is shipped with the beam in the

vertical position. Pull out the vertical beam lock,

rotate it back, and pivot the beam to the horizontal

position until it locks. See Figure 2.

Vertical

Beam Lock

Figure 2

Disconnect the dislodger from the beam weld

bracket by removing the six hex screws and flat

washers. See Figure 3.

Hex Screw

Rex

Flat Washer

"_Dislodger

Weld Bracket

Figure 3

1 2 3 4 5 6 7 8 9 10 ... 15 16

Komentáře k této Příručce

Žádné komentáře

MTD 550 Thru 570 Návod k obsluze Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Rozdělovače protokolů MTD 550 Thru 570