Mtd 219-320-000 Uživatelský manuál

$1.00OWNEirS GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTSCHAIN DRIVE TILLERModel Number 219-320-000Important: Read Safety Rules and Instructions Ca

WHEEL POSITIONThe tiller is shipped with the wheels adjusted sue h that the unit sits level. During digging as the tines enl er the ground and the fro

5m3gn VWv.'W-'lipi.vvSijSS4 4.Tilling widtn can be reduced from 26 inches to 24 inches by removing the clevis pins and hairpin clip

ADJUSTMENTSAI WARNING \Disconnect the spark plug wire and ground against the engine before performing any adjustments, repairs, or mainten

TROUBLE SHOOTINGRefer to page 14 of this manual for trouble shooting information.ENGINERefer to the separate engine manual for all en

A^ WARNING \DO NOT DRAIN FUEL WHILE SMOKING, OR IF NEAR AN OPEN FIRE.2. Drain all the oil from the crankcase (this shoi Id be done after the engin

Model 320NOTE: Use 12 ounces ofPlastilube #0Order Part No. 737-0133PARTS LIST FOR CHAIN CASE 784-0103REF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDE

Model 32016

Model 320PARTS LIST FOR MODEL 320 TILLERREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODE DESCRIPTION1749-0356A NHandle—R.H.25 736-0176 FI-Wash. .25&quo

Model 32030 ci\\/3221 2018

Model 320PARTS LIST FOR MODEL 320 TILLERREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1__Engine22736-0169L-Wash. 3/8" I.D.*2710-0600H

INDEXSafe Operation Practices...3Assembly Instructions... ... .4

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firm; listed below. All orders shou

AI WARNING {To reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instruct

NOTEReference to left or right side of the tiller is determined from behind the unit in the operating position.TailpieceASSEMBLY INSTRUCTI

Hole Provied for TailpieceTailpiece“U”-Channel BracketNOTEWheel hanger bracket must be removed before the “U’’-channel can be pivoted down.2

FIGURE 8.NOTEIf the handle panel was preassembled on your unit, omit steps 4 and 5.4. Place the handle panel in position on the handles. Secure with

2.Remove one nut and lock washer from other end of clutch cable. Slip the wire up through slot on clutch cable bracket. Start hex nut and

6. Secure the throttle control cable and clutch control cable to the handles with cable ties (J) provid- —ed. Cut off excess ends. See figure 13.FIG

CONTROLSFIGURE 16.THROTTLE CONTROLThe throttle control lever is located on the handle panel. It controls the engine speed and stops the engine. See fi