MTD 70 Series Specifikace stáhnout pdf (Strana 67)

CYLINDER HEAD

The Cylinder head of the MTD engine can be removed

without removing the engine from the piece of equip-

ment.

To remove the cylinder head:

1. Disconnect and ground the spark plug high ten-

sion lead.

2. Remove the spark plug using a 13/16” or 21mm

wrench.

3. Rotate the crankshaft until it is at TDC of the

compression stroke by following the steps

described in the valve lash section of Chapter 1:

Introduction..

4. Remove the carburetor and insulator plate by

following the steps described in Chapter 3: Air

Intake Systems.

5. Disconnect the throttle stop switch. See Figure

9.1.

Figure 9.1

Disconnect switch

6. Remove the throttle lever by removing the two

screws using a 8mm wrench.

See Figure 9.2.

7. Remove the muffler by following the steps

described in Chapter 8: Exhaust.

8. Remove the heat baffle. See Figure 9.3.

Figure 9.2

Figure 9.3

Heat baffle

Remove these screws

CHAPTER 9: CYLINDER HEAD

www.mymowerparts.com

For Discount White Outdoor Parts Call 606-678-9623 or 606-561-4983

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 88 89

Žádné komentáře

MTD 70 Series Specifikace Strana 67